Cura software
Cura
Our software Cura will be used in order to set up your Ultimaker Original+. Cura contains a “configuration wizard” that helps you preparing your Ultimaker Original+ for the first print.
Installation
After downloading, open the installer and run the installation wizard to complete the installation. When you open up Cura for the first time, you will be asked to select the 3D printer that you have; select the Ultimaker Original+. Now, Cura will automatically guide you through the “configuration wizard”.
-
Ultimaker S5
- Get started
- Operation
-
Maintenance
- Update the firmware
- Material handling and storage
- Maintenance schedule
- Clean the printer
- Lubricate the axles
- Check for play on the axles
- Check the tension of the short belts
- Check for debris in the front fan of the print head
- Check the quality of the nozzle cover
- Lubricate the Z screw of the Z motor
- Clean the feeders
- Clean the print cores
- Lubricate the feeder gear
- Replace the Bowden tubes
- Clean the system fans
- Lubricate the hinges
- Troubleshooting
- Downloads
- More support
-
Ultimaker 3
- Get started
- Operation
-
Maintenance
- Updating the firmware
- Storage and handling of materials
- Maintenance schedule
- Clean the printer
- Lubricate the axles
- Check for play on axles
- Check the tension of the short belts
- Check for residue in the front fan of the print head
- Check the quality of the silicone nozzle cover
- Lubricate the lead screw of the Z motor
- Clean the print cores
- Clean the feeders
- Replace the Bowden tubes
- Troubleshooting
- Downloads
- FAQ
- More support
-
Ultimaker 2+
- Get started
- Operation
-
Maintenance
- Updating the firmware
- Build plate calibration
- Storage and handling of materials
- Hardware maintenance
- Clean the printer
- Lubricate the axles
- Check for play on axles
- Check tension of short belts
- Lubricate the lead screw of the Z motor
- Retighten the hot-end isolator
- Clean the feeder and replace the Bowden tube
- Troubleshooting
- Downloads
- More support
-
Ultimaker Original+
-
Assembly
- Assembly
- What's in the box?
- Preparing the panels
- Assembling the frame
- Attaching various parts
- Sliding blocks
- Attaching the caps
- X and Y axles
- Z stage assembly
- Z stage installation
- Print head assembly
- Print head installation
- Aligning the print head
- Feeder assembly
- Bowden tube
- Spool holder
- UltiController
- Mounting the main board
- Connecting
- Electronics cover
- First use
- Printing
- Maintenance
- Troubleshooting
- Additional information
-
Assembly
